Filter
Top Products
42 SPX2000—Owner’s Manual
■Fine parameters
Effect list
The following tables show the default parameter values for the effects belonging to the Modulation Delay type (PRESET
bank).
■Basic parameters
■Fine parameters
Parameter name Range Explanation
MIX BAL. 0—100%
Balance between the original sound and effect sound. At a setting of 0% only the original sound
will be output; at a setting of 100% only the effect sound will be output.
OUT LVL 0—100%
Output level after the original sound and effect sound have been mixed. Decrease this value if you
want to lower the output. At a setting of 0% there will be no output.
HPF Thru, 21.2 Hz—8.00 kHz
A filter that cuts the low-frequency portion of the effect. Frequency components lower than the
frequency specified here will be cut. With a setting of Thru this filter will do nothing. This filter
does not affect the original sound.
LPF 50.0 Hz—16.0 kHz, Thru
A filter that cuts the high-frequency portion of the effect. Frequency components above the fre-
quency specified here will be cut. With a setting of Thru this filter will do nothing. This filter does
not affect the original sound.
SYNC ON, OFF
Switches tempo synchronization on/off. If this is ON, the delay will synchronize to the tempo syn-
chronization source specified by “TEMPO SOURCE” (page 23). The DLY.NOTE and the
MOD.NOTE value will be set to the synchronized tempo value.
DLY.NOTE
*a
*a.
This parameter is used for tempo synchronization. If SYNC is ON, the DELAY value will be set
according to this value and TEMPO. If SYNC is OFF, this value is ignored.
MOD.NOTE
*b
*b.
This parameter is used for tempo synchronization. If SYNC is ON, the FREQ. value will be set
according to this value and TEMPO. If SYNC is OFF, this value is ignored.
TEMPO 25—300
This parameter is used for tempo synchronization. If SYNC is ON, the DELAY value will be set
according to the DLY.NOTE and TEMPO values, and the FREQ. value will be set according to the
MOD.NOTE and TEMPO values. If SYNC is OFF, this value is ignored.
No. Effect name DELAY FB.GAIN HI.RATIO FREQ. DEPTH WAVE
66 STEREO PHASING 2.0 ms +38% 0.9 0.90 Hz 46% Sine
68 SILKY SWEEP 0.2 ms –40% 1.0 0.30 Hz 80% Sine
No. Effect name MIX BAL. OUT LVL HPF LPF SYNC DLY.NOTE MOD.NOTE TEMPO
66 STEREO PHASING 100% 100% 45.0 Hz 9.00 kHz OFF —
68 SILKY SWEEP 100% 100% 125 Hz Thru OFF —