Filter
Top Products
16 SPX2000—Owner’s Manual
Press the [COMPARE] button (I) to compare the origi-
nal effect with the edited version.
→ Each time you press this button, the [COMPARE] LED
will alternate between lit and blinking. The LED will
light if the edited effect is selected, and will blink if the
unedited effect is selected.
Here’s how to specify a location in the USER bank and
store the edited effect.
1 Select the USER bank
Press the [BANK] button (A) several times to select
the USER bank.
→ The [BANK] indicator (A) will indicate “USER.”
2 Select a store-destination for the effect
Use the [▲]/[▼] buttons (C) to specify the effect
number in which you will store the effect you edited.
→ The effect number indicator (0) shows the cur-
rently selected effect number.
3 Store the effect
Press the [STORE] button (B) to store the effect.
→ The [COMPARE] LED (I) will go dark, and the
[UNDO] LED (E) will light.
You can return settings to their prior state by “undoing”
the previous Store, Recall, or Clear Effect operation. You
can also “undo” the previous “undo” operation; this is
called “redo.”
Undo
When the [UNDO] LED (E) is lit, press the [UNDO] but-
ton to undo the previous Store, Recall, or Clear Effect
operation.
→ The [UNDO] LED will blink.
Redo
When the [UNDO] LED (E) is blinking, press the
[UNDO] button to cancel the previous Undo operation.
→ The [UNDO] LED will light.
Check the edited effect
NOTE:
The following buttons are inoperable while the [COMPARE]
LED is blinking.
• [
▲
INC]/[
▼
DEC] buttons (
G
)
• [UTILITY] buttons (
L
)
• [TAP] button (
N
)
Store the effect
Undoing the previous operation
NOTE: Undo/Redo will no longer be available if you switch
parameters.