Filter
Top Products
70 SPX2000—Owner’s Manual
■Fine parameters
Effect list
■Basic parameters
■Fine parameters
Parameter name Range Explanation
MIX BAL. 0—100%
Balance between the original sound and effect sound. At a setting of 0% only the original sound
will be output; at a setting of 100% only the effect sound will be output.
OUT LVL 0—100%
Output level after the original sound and effect sound have been mixed.
Decrease this value if you want to lower the output. At a setting of 0% there will be no output.
HPF Thru, 21.2 Hz—8.00 kHz
A filter that cuts the low-frequency portion of the effect. Frequency components lower than the
frequency specified here will be cut. With a setting of Thru this filter will do nothing. This filter
does not affect the original sound.
LPF 50.0 Hz—16.0 kHz, Thru
A filter that cuts the high-frequency portion of the effect. Frequency components above the fre-
quency specified here will be cut. With a setting of Thru this filter will do nothing. This filter does
not affect the original sound.
REV/FLG 0—100%
(Reverb + Flanger only) Balance between the reverb and flanger. A setting of 0% outputs only the
reverb; a setting of 100% outputs only the flanger.
REV.BAL 0—100%
(Reverb → Flanger only) Amount of flanger. Raising this value will strengthen the flanger effect. At
a setting of 0% only reverb will be heard.
SYNC ON, OFF
Switches tempo synchronization on/off. If this is ON, the speed of modulation will synchronize to
the tempo synchronization source specified by “TEMPO SOURCE” (page 23). The NOTE value
will be set to the synchronized tempo value.
NOTE
*a
*a.
This parameter is used for tempo synchronization. If SYNC is ON, the FREQ. value will be set
according to this value and TEMPO. If SYNC is OFF, this value is ignored.
TEMPO 25—300
This parameter is used for tempo synchronization. If SYNC is ON, the FREQ. value will be set
according to this value and NOTE. If SYNC is OFF, this value is ignored.
No. Effect name FREQ. DEPTH MOD.DLY FB.GAIN WAVE REV TIME HI.RATIO INI.DLY DIFF. DENSITY
14 REVERB FLANGE 1.10 Hz 80% 1.2 ms +10% Sine 2.4 s 0.4 0.1 ms 5 95%
87 REV+FLANGE 0.25 Hz 88% 0.3 ms –84% Tri 1.9 s 0.7 2.4 ms 10 100%
No. Effect name MIX BAL. OUT LVL HPF LPF REV/FLG REV.BAL SYNC NOTE TEMPO
14 REVERB FLANGE 76% 100% Thru 4.25 kHz
60% OFF —
87 REV+FLANGE 100% 100% Thru Thru 67%
OFF —