Filter
Top Products
98 SPX2000—Owner’s Manual
Troubleshooting
If the SPX2000 does not function as you expect, or if you suspect a problem, please check the following points.
Power does not turn on
•Is the power cable connected to an AC outlet of the correct voltage?
•Is the POWER switch turned ON?
The input sound is not sent from
the outputs
•Is your external equipment correctly connected with the SPX2000?
•Could the cables connected to/from your external equipment be broken?
•Is a signal being input from your external device?
•Is the [INPUT L R] control (1) set to an appropriate level?
•Is the INPUT SOURCE set appropriately? (For details, refer to page 19.)
•Is the CLOCK SOURCE set appropriately? (For details, refer to page 18.)
•Could output-related parameters such as OUT LVL and LEVEL be set to 0%?
•Is the signal output when you turn the [BYPASS] button (M) on? (Some
effects do not output a signal at all times.)
Noise is heard in the output • Is the CLOCK SOURCE set appropriately? (For details, refer to page 18.)
Signal level does not match the
external device
•Are the rear panel [OUTPUT –10 dBu/+4 dBu] switch and the [INPUT –10
dBu/+4 dBu] switch set correctly?
Some buttons are inoperable
•Could the [UTILITY] button be on (LED lit)? (see page 8)
•Could the [COMPARE] button be on (LED blinking)? (see page 16)
TEMPO and NOTE settings do not
produce the timing you expect
•Is the SYNC setting turned on? (For details, refer to page 15.)
Can’t transfer MIDI data
•Have you made the correct preparations for using MIDI? (see page 88)
•Is the MIDI cable (USB cable) connected correctly?
•Could the MIDI cable (USB cable) be broken?