Filter
Top Products
62 SPX2000—Owner’s Manual
Effect list
The following tables show the default parameter values for the effect belonging to the High Quality Pitch type (PRESET
bank).
■Basic parameters
■Fine parameters
Dual Pitch (PRESET bank)
This is essentially the same as High Quality Pitch, but there are two effect sounds whose pitch can be specified independently.
Each aspect of the sound is controlled by the following effect parameters.
Effect sound 1: PITCH 1, FINE 1, DELAY 1, FB.G 1, MODE
Effect sound 2: PITCH 2, FINE 2, DELAY 2, FB.G 2, MODE
Tempo synchronization: SYNC, NOTE 1, NOTE 2, TEMPO
Output level: LEVEL 1, LEVEL 2, MIX BAL.
Parameter details
■Basic parameters
■Fine parameters
No. Effect name PITCH FINE DELAY FB.GAIN
58 ROGER ON THE 12 +12 0 0.0 ms 0%
No. Effect name MIX BAL. OUT LVL MODE SYNC NOTE TEMPO
58 ROGER ON THE 12 100% 90% 6 OFF —
Parameter name Range Explanation
PITCH 1
PITCH 2
–24—+24
Amount of pitch change, adjusted in semitone steps. Positive (+) settings make the pitch higher
than the original sound, and negative (–) settings make it lower.
FINE 1
FINE 2
–50—+50
Amount of pitch change, adjusted in steps of one cent (1/100th of a semitone). Positive (+) settings
make the pitch higher than the original sound, and negative (–) settings make it lower.
DELAY 1
DELAY 2
0.0—1000.0 ms
Delay of the effect sound relative to the original sound.
FB.G 1
FB.G 2
–99%—+99%
Amount of feedback for the effect sound. Raising this value will increase the amount of feedback,
emphasizing the pitch change. Negative (–) settings will invert the phase of the feedback.
LEVEL 1
LEVEL 2
–100%—+100%
Output levels of the effect 1 and effect 2 sounds. LEVEL 1 is the output level for effect sound 1, and
LEVEL 2 is the output level for effect sound 2.
Negative (–) settings invert the phase.
PAN 1
PAN 2
L63—R63
Position of each effect sound. L63 is far left, and R63 is far right.
Parameter name Range Explanation
MIX BAL. 0—100%
Balance between the original sound and effect sound. At a setting of 0% only the original sound
will be output; at a setting of 100% only the effect sound will be output.
MODE 1—10
Precision of the pitch change. Higher settings produce a more accurate pitch change, but the delay
error will be greater.
SYNC ON, OFF
Switches tempo synchronization on/off. If this is ON, the delay time will synchronize to the tempo
synchronization source specified by the “TEMPO SOURCE” setting (page 23). The NOTE 1 and
the NOTE 2 value will be set to the synchronized tempo value.
NOTE 1
NOTE 2
*a
*a.
These parameters are used for tempo synchronization. If SYNC is ON, the DELAY 1 value will be
set according to the NOTE 1 and TEMPO values, and the DELAY 2 value will be set according to
the NOTE 2 and TEMPO values. If SYNC is OFF, this value is ignored.
TEMPO 25—300
These parameters are used for tempo synchronization. If SYNC is ON, the DELAY 1 value will be
set according to the NOTE 1 and TEMPO values, and the DELAY 2 value will be set according to
the NOTE 2 and TEMPO values. If SYNC is OFF, this value is ignored.