Filter
Top Products
SPX2000—Owner’s Manual 11
Operation
You will need to make several selections regarding the
input signal.
Select monaural or stereo input
Use the [INPUT MODE] button (3) to select either mon-
aural input or stereo input. Each time you press the
[INPUT MODE] button the indicator will alternate
between MONO and STEREO.
The signal flow will change as follows depending on
whether the input is monaural or stereo, and on the num-
ber of inputs/outputs for the effect you recall.
Select the signal for metering
Use the [METER] button (4) to select either the pre-
effect signal or the post-effect signal for display in the level
meter (2). Each time you press the [METER] button the
indicator will alternate between INPUT and OUTPUT.
Check the status of the input signal
The following indicators will light to indicate the state of
the input signal.
• INPUT SOURCE (5):
This will indicate whether the input signal is ANALOG
or DIGITAL. If you want to change input sources, use
“INPUT SOURCE” (page 19) to select the desired input
source.
• MIDI (7):
This indicator will light when MIDI data is received.
• CLOCK (6):
This indicates the word clock source. Use “CLOCK
SOURCE” (page 18) to select the word clock source.
• kHz (8)
This indicates the word clock frequency (44.1/48/88.2/96
kHz). If you are using the SPX2000’s internal clock, you
can use “CLOCK SOURCE” (page 18) to select the fre-
quency.
Use the [INPUT L R] control (1) to adjust the analog
input signal levels (L/R); the inner knob controls the L
channel, and the outer knob controls the R channel.
Select the input signal
FX
IN L
IN R OUT R
OUT L
L
R
C
–3 dB
–3 dB
FX
IN L
IN R OUT R
OUT L
L
R
L
R
FX
IN L
(MONO)
IN L
(MONO)
IN R OUT R
OUT L
L
R
C
FX
IN R OUT R
OUT L
L
R
L
R
Monaural input 1IN 2OUT
Monaural input 2IN 2OUT
Stereo input 1IN 2OUT
Stereo input 2IN 2OUT
INT
The SPX2000’s internal clock
The SPX2000 will operate as the
clock master.
You will need to set other con-
nected devices to be clock slaves.
AES/EBU
Clock data received at the [AES/EBU IN]
jack (X)
The SPX2000 will operate as a clock
slave.
WC
Clock will be received at the [WORD
CLOCK IN] jack (V)
The SPX2000 will operate as a clock
slave.
Adjust the input level