Filter
Top Products
40 SPX2000—Owner’s Manual
Stereo Delay (PRESET bank)
This effect adds two delayed sounds; one each for the L and R channels. You can control each delay independently.
Each aspect of the sound is controlled by the following effect parameters.
Delay sound: DELAY L, DELAY R, FB.G L, FB.G R, HI.RATIO
Tempo synchronization: SYNC, NOTE L, NOTE R, TEMPO
Filter/equalizer: HPF, LPF
Output level: OUT LVL, MIX BAL.
Parameter details
■Basic parameters
■Fine parameters
Parameter name Range Explanation
DELAY L
DELAY R
0.0—1350.0 ms
Delay relative to the original sound. DELAY L indicates the L channel delay, and DELAY R indi-
cates the R channel delay.
FB.G L
FB.G R
–99%—+99%
Amount of feedback for the delay sounds. This indicates the ratio by which the level is reduced
when repeating the effect. For example with a setting of +50, the level of the delay sound will decay
to 50% → 25% → 12.5% as it is repeated. Negative (–) values invert the phase of the feedback.
FB.G L indicates the feedback amount for the L channel, and FB.G R for the R channel.
HI.RATIO 0.1—1.0
Amount of feedback for the high-frequency portion of the delay sound. This is specified as a pro-
portion of FB.G. If this value is 0.1, the high-frequency feedback amount for the L channel will be
1/10th of FB.G L, and the high-frequency feedback amount for the R channel will be 1/10th of
FB.G R. If this value is set to 1.0, the high-frequency range feedback will be the same as the FB.G L
or FB.G R.
Parameter name Range Explanation
MIX BAL. 0—100%
Balance between the original sound and effect sound. At a setting of 0% only the original sound
will be output; at a setting of 100% only the effect sound will be output.
OUT LVL 0—100%
Output level after the original sound and effect sound have been mixed. Decrease this value if you
want to lower the output. At a setting of 0% there will be no output.
HPF Thru, 21.2 Hz—8.00 kHz
A filter that cuts the low-frequency portion of the effect. Frequency components lower than the
frequency specified here will be cut. With a setting of Thru this filter will do nothing. This filter
does not affect the original sound.
LPF 50.0 Hz—16.0 kHz, Thru
A filter that cuts the high-frequency portion of the effect. Frequency components above the fre-
quency specified here will be cut. With a setting of Thru this filter will do nothing. This filter does
not affect the original sound.
SYNC ON, OFF
Switches tempo synchronization on/off. If this is ON, the delay will synchronize to the tempo syn-
chronization source specified by “TEMPO SOURCE” (page 23). The NOTE L and the NOTE R
value will be set to the synchronized tempo value.
NOTE L
NOTE R
*a
*a.
These parameters are used for tempo synchronization. If SYNC is ON, the DELAY L value will be
set according to the NOTE L and TEMPO values, and the DELAY R value will be set according to
the NOTE R and TEMPO values. If SYNC is OFF, this value is ignored.
TEMPO 25—300
This parameter is used for tempo synchronization. If SYNC is ON, the DELAY value will be set
according to this value and NOTE. If SYNC is OFF, this value is ignored.
DELAY L
DELAY R
LR
R
R
R
R
L
DELAY L
L
Level
Time
Original sound
IN R
IN L
MIX
BAL.
OUT L
OUT R
DELAY R
DELAY L
HPF LPF
FB.G L
FB.G R