Filter
Top Products
12 SPX2000—Owner’s Manual
Here’s how to select the effect that you want to apply to the
input signal.
1 Select a bank
Press the [BANK] button (A) several times to select
the bank that contains the desired effect.
→ The [BANK] indicator (A) shows the currently
selected bank.
2 Select an effect
Use the [▲]/[▼] buttons (C) to select the effect you
want to use.
→ The number of the currently-selected effect will
blink in the effect number indicator (0).
Press the [RECALL] button (D) to recall the effect.
→ The recalled effect will be applied to the output signal.
You can use the [BYPASS] button (M) to switch the effect
on/off.
→ Each time you press the button the effect will be
switched on/off. When the [BYPASS] button is on, the
effect will be off and the input signal will be output
without modification.
Three banks
The SPX2000 has three effect banks; PRESET,
USER, and CLASSIC. These banks are organized as
follows.
PRESET bank
This bank contains a total of 97 effects; 80
effects based on new algorithms and ranging
from standard to distinctive, and 17 newly-
developed reverb (REV-X) effects.
The effects in this bank are read-only.
CLASSIC bank
This bank contains 25 simple and easy-to-use
effects based on early models of the SPX series.
The effects in this bank are read-only.
USER bank
When shipped, this bank does not contain
effects. You can edit effects from the PRESET
bank or CLASSIC bank and store them as your
own original effects in the USER bank. Once
you have stored an effect, you can recall and use
it in the same way as the effects of the PRESET
bank or CLASSIC bank.
You can store 99 effects in this bank.
Select an effect
[▲] button
Press to move to the following effect.
Hold
to continue moving through
the following effects.
Hold down
[▲] and
press [▼]
to move more rapidly through
the following effects.
[▼] button
Press to move to the preceding effect.
Hold
to continue moving through
the preceding effects.
Hold down
[▼] and
press [▲]
to move more rapidly through
the preceding effects.
NOTE: The following buttons will be inoperable when the
[UTILITY] LED (
L
) is lit
• [BANK] button (
A
)
• [STORE] button (
B
)
• [
▲
]/[
▼
] buttons (
C
)
• [RECALL] button (
D
)
• [UNDO] button (
E
)
• [COMPARE] button (
I
)
NOTE: While you are selecting an effect (i.e., while the effect
number indicator is blinking), pressing any of the following
buttons will cancel the effect selection; the currently-recalled
effect will appear in the display.
• [UNDO] button (
E
)
• [BACK] button (
F
)
• [
▲
INC]/[
▼
DEC] buttons (
G
)
• [NEXT] button (
H
)
• [COMPARE] button (
I
)
• [PARAMETER] button (
J
)
• [FINE PARAM] button (
K
)
Recall the effect
NOTE: You can press the [UNDO] button (
E
) to undo the
preceding Recall operation. The [UNDO] LED will light if UNDO
is available.
Switch the effect on/off