Commands by Subsystem 3
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference 211
:MARKer:Y1Position
(see page 530)
Command Syntax
:MARKer:Y1Position <position> [suffix]
<position> ::= Y1 cursor position in NR3 format
<suffix> ::= {mV | V | dB}
The :MARKer:Y1Position command sets :MARKer:MODE to MANual, sets
the Y1 cursor position and moves the Y1 cursor to the specified value.
Query Syntax
:MARKer:Y1Position?
The :MARKer:Y1Position? query returns current Y1 cursor position. If the
front-panel cursors are off an error is returned. This is functionally
equivalent to the obsolete :MEASure:VSTArt command/query
Return Format
<position><NL>
<position> ::= Y1 cursor position in NR3 format
See Also • "Introduction to :MARKer Commands" on page 204
• ":MARKer:MODE" on page 205
• ":MARKer:X1Y1source" on page 207
• ":MARKer:X2Y2source" on page 209
• ":MARKer:Y2Position" on page 212
• ":MEASure:VSTArt" on page 490
