A SERVICE OF

logo

Open as PDF
next previous
Commands by Subsystem 3
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference 273
:SAVE:WAVeform[:STARt]
(see page 530)
Command Syntax
:SAVE:WAVeform[:STARt] [<file_name>]
<file_name> ::= quoted ASCII string
The :SAVE:WAVeform[:STARt] command saves oscilloscope waveform data
to a file.
See Also • "Introduction to :SAVE Commands" on page 263
• ":SAVE:WAVeform:FORMat" on page 274
• ":SAVE:WAVeform:LENGth" on page 275
• ":SAVE:FILename" on page 264
• ":RECall:SETup[:STARt]" on page 261
NOTE
If a file extension is provided as part of a specified <file_name>, it must match the
extension expected by the format specified in :SAVE:WAVeform:FORMat.