Obsolete and Discontinued Commands 5
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference 497
:TRIGger:LIN:SIGNal:DEFinition
(see page 530)
Command Syntax
:TRIGger:LIN:SIGNal:DEFinition <value>
<value> ::= {LIN | RX | TX}
The :TRIGger:LIN:SIGNal:DEFinition command sets the LIN signal type.
These signals can be set to:
Dominant low signals:
• LIN — the actual LIN single- end bus signal line.
• RX — the Receive signal from the LIN bus transceiver.
• TX — the Transmit signal to the LIN bus transceiver.
Query Syntax
:TRIGger:LIN:SIGNal:DEFinition?
The :TRIGger:LIN:SIGNal:DEFinition? query returns the current LIN signal
type.
Return Format
<value><NL>
<value> ::= LIN
See Also • "Introduction to :TRIGger Commands" on page 313
• ":TRIGger:MODE" on page 319
• ":TRIGger:LIN:SIGNal:BAUDrate" on page 367
• ":TRIGger:LIN:SOURce" on page 368
NOTE
With InfiniiVision 5000 Series oscilloscope software version 5.00 or greater, this command
is available, but the only legal value is LIN.
