286 Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Reference
3 Commands by Subsystem
:SBUS:MODE
(see page 530)
Command Syntax
:SBUS:MODE <mode>
<mode> ::= {IIC | SPI | CAN | LIN | UART}
The :SBUS:MODE command determines the decode mode for the serial
bus.
Query Syntax
:SBUS:MODE?
The :SBUS:MODE? query returns the current serial bus decode mode
setting.
Return Format
<mode><NL>
<mode> ::= {IIC | SPI | CAN | LIN | UART | NONE}
Errors • "- 241, Hardware missing" on page 501
See Also • "Introduction to :SBUS Commands" on page 277
• ":TRIGger:MODE" on page 319
• ":TRIGger:IIC Commands" on page 355
• ":TRIGger:SPI Commands" on page 372
• ":TRIGger:CAN Commands" on page 324
• ":TRIGger:LIN Commands" on page 364
• ":TRIGger:UART Commands" on page 387
NOTE
This command is only valid on 4 (analog) channel oscilloscope models when a serial decode
option has been licensed.
