Filter
Top Products
Selecting and Creating Tones
E-24
■ Editable Parameters of Blocks (1) through (6)
•The nine sliders (
5
) and four knobs (
3
) can be used for quick and easy adjustment of some of the parameters in the list
below (page
E-35).
Preparation
Perform the following steps from the screen in step 2 of the procedure under “To edit and save a tone as a user tone” on page
E-21.
1.
Select “OSC Block >Ent” and then press
bq
ENTER to enter the group.
2.
Use the
9
PART minus (–) and plus (+) buttons to select the block you want to edit.
Editable Parameter List
• Shaded cells indicate a group made up of multiple items. Press
bq
ENTER to display the items that make up a group.
• (V) at the end of a display item indicates an item that can be selected as a Block (10) virtual controller destination (page E-29).
Display Text Description Settings
OSC On Off OSC on/off. Selecting off disables the entire block. Off, On
Oscillator >Ent (Block (1) to (5) only)
Oscillator. Group of editable parameters associated with the pitch of the synth
OSC, PCM OSC, and pitch shift.
• This group can be entered by performing step 1 under “To edit and save a tone
as a user tone” (page E-21) and then holding down
7
EDIT.
Synth Wave
(Blocks (1) and (2) only)
PCM Wave
(Blocks (3) and (4) only)
Synth wave, PCM wave. Selects the base wave for a sound generated by the
synth OSC or PCM OSC.
• A wave whose name is displayed with “L” or “B” next to it will sound at a pitch
that is one octave lower than the actual pitch. In the case of a “B” wave, nothing
will sound when a keyboard key higher than C5 is pressed.
• See the separate “Appendix” for details about wave types.
• This item is not present in Block (5).
See the separate
“Appendix”.
Pitch (V)
Pitch. Adjusts the maximum and minimum pitch values within a range of ±2
octaves. A setting of –256 lowers the pitch two octaves, while a setting of 255
raises the pitch two octaves.
–256 to 0 to +255
Detune (V) Detune. Fine adjustment of the tuning. –256 to 0 to +255
KeyFollow (V)
Key follow. Adjusts the amount of pitch change between neighboring keyboard
keys. A higher value represents greater change.
Example: When Key Follow Base is keyboard key C4
–128 to 0 to +127
KeyFolBase (V)
Key follow base. Keyboard key that is the center of key follow.
• Setting value can be specified using the keyboard keys.
C-1 to G9
Env.Depth (V) Envelope depth. Specifies how the envelope shown below is applied. –64 to 0 to +63
Block
Syn1: Synth OSC1
Syn2: Synth OSC2
PCM1: PCM OSC1
PCM2: PCM OSC2
Ext: External input
Noise: Noise
D
4
C
#
4
C
4
C
4
Key Follow = 127
Key Follow = 64
Key Follow = 0
Key Follow = -127
C
#
4
B
b
4
Key Follow
Key Follow Base
B