Filter
Top Products
Selecting and Creating Tones
E-28
■ Block (8): LFO1 and Block (9): LFO2 Editable Parameters
Preparation
Perform the following steps from the screen in step 2 of the procedure under “To edit and save a tone as a user tone” on page
E-21.
1.
Select “LFO >Ent” and then press
bq
ENTER to enter the group.
2.
Use the
9
PART minus (–) and plus (+) buttons to select the block you want to edit.
Editable Parameter List
• (V) at the end of a display item indicates an item that can be selected as a Block (10) virtual controller destination (page E-29).
Display Text Description Settings
WaveType
Wave type. Specifies one of the following wave types to be used for LFO.
Refer to the cell to the
left.
Sync
Sync. Specifies what LFO is synced with.
Off: No syncing
Tempo: Synced with beat specified by clock sync (see below).
LFO1 (Can be selected with LFO2 only.): Synced with LFO1.
Refer to the cell to the
left.
Rate (V)
Rate. Specifies the LFO speed (frequency). This setting is enabled when the above Sync setting is
off.
0 to 127
Clk.Sync
Clock sync. Specifies the number of beats synced with the LFO frequency. Selecting a setting from
1/4U to 4U syncs with the timing of the back beat.
• This setting a valid only when the sync setting is “Tempo”.
1/4, 1/3, 1/2, 2/3, 1, 3/2,
2, 3, 4, 1/4U, 1/3U, 1/2U,
2/3U, 1U, 3/2U, 2U, 3U,
4U
Depth (V) Depth. Specifies how LFO is applied. 0 to 127
Delay (V) Delay. Specifies the degree of delay in the timing for applying LFO. 0 to 127
Rise (V)
Rise. Specifies the time it takes from the start of application of the LFO until the effect reaches the
level specified by Depth above.
0 to 127
Mod.Depth (V) Modulation depth. Specifies how modulation is applied to the LFO. 0 to 127
Sin
(Sine Wave)
Puls 1:3
(Square Wave 1:3)
Tri
(Triangular Wave)
Puls 2:2
(Square Wave 2:2)
Saw up
(Sawtooth Wave Up)
Puls 3:1
(Square Wave 3:1)
Saw down
(Sawtooth Wave
Down)
Random
(Random)