Filter
Top Products
Selecting and Creating Tones
E-34
The editable parameters described here are for the drum set tones in the Variance tone category. There are two types of
parameters: PCM drum tone specific editable parameters and the same parameters that apply to the other tone categories.
■ Editable Drum Set PCM Tone Parameters
Preparation
Display the screen in step 2 of the procedure under “To edit and save a tone as a user tone” on page E-21.
Editable Parameter List
• Shaded cells indicate a group made up of multiple items. Press
bq
ENTER to display the items that make up a group.
■ Editable Parameters Common to Other Tone Categories
For information about Solo Synthesizer tones, see “Other Editable Items” on page E-29.
Editable Drum PCM Tone Parameters
Display Text Description Settings
Inst Edit >Ent
Instrument edit. Group of editable drum tone parameters for each
keyboard.
• Press a keyboard key to specify the keyboard to be edited.
• This group can be entered by performing step 1 under “To edit and save
a tone as a user tone” (page E-21) and then holding down
7
EDIT.
(C-1 to G9)
Inst Select >Ent
Instrument select. Group of editable tone parameters. Keyboard key
pressure (Velocity) is divided into four velocity ranges. Each range can be
configured to sound a different tone (Inst Number).
•Use the
9
PART minus (–) and plus (+) buttons to select the range
you want to edit.
Inst Number
Instrument number. Selects the drum tone wave assigned to each
velocity range.
• See the separate “Appendix” for details about wave types.
See the separate
“Appendix”.
VelRangeHi Velocity range high. Determines the high limit of each velocity range. 0 to 127
Volume Volume. Specifies drum sound volume. –128 to 0 to +127
Pan Pan. Specifies the stereo position of drum sound. –64 to 0 to +63
Rev.Send Reverb send. Specifies how reverb is applied to a drum tone. 0 to 127
NoteOffMode
Note off mode. Turning on this setting causes note off to be performed
when a key is released.
Off, On
Assign Grp
Assign group. Specifies as a value from 1 to 15 which group the currently
selected keyboard should be placed into. Only one keyboard in a group is
sounded at any time (non-polyphonic).
Off, 1 to 15
Pitch LFO >Ent
Pitch LFO. Group of editable LFOs applied to pitch. Group items and
setting ranges are the same as “LFO (Pitch LFO)” under “Editable
Parameters for All Layers (Layer 1 through Layer 6)” (page E-31).
Refer to the cell to the
left.
Amp LFO >Ent
Amp LFO. Group of editable LFOs applied to volume. Group items and
setting ranges are the same as “LFO (Amp LFO)” under “Editable
Parameters for All Layers (Layer 1 through Layer 6)” (page E-31).
Refer to the cell to the
left.
Inst Number
[1] [2] [3] [4]
Cannot be
specified.
range 1 range 2 range 3 range 4
0
Velocity Range Hi
[1] [2] [3] [4] 127 Velocity
B