Filter
Top Products
Selecting and Creating Tones
E-38
1.
Hold down
bm
EFFECT until the effect list top screen shown below appears.
2.
Next, refer to the list below as you perform operations with the
bq
controls to select items and change
settings.
■ Effect Settings
To configure effect settings
bm
Display Description Settings
Rev Type Reverb type. Reverb effect type. Type1, Type2
Rev Level Reverb level. Reverb effect level. 0 to 127
Rev Time Reverb time. Reverb sustain time. 0 to 127
Cho Level Chorus level. Chorus effect level. 0 to 127
Cho Rate Chorus rate. Rate of chorus effect undulation. 0 to 127
ChoSendRev
Chorus send level to reverb. Specifies how reverb is applied to the entire sound to which
the chorus effect is being applied.
0 to 127
Cho/DSP
Chorus/DSP select. Selects use of either Chorus or Normal DSP (“Chorus and DSP Use
Restrictions”, page E-37).
Cho, DSP
DSP Select >Ent
Displays the main Normal DSP selection screen.
• You will not be able to go any further if a Solo Synthesizer tone is selected for Zone Part
1.
(Normal DSP
selection
screen)
You can select from among preset and user tones for the Normal DSP using the same
procedures as those for tone selection.
• For a list of preset Normal DSPs, see the separate Appendix. Selecting “ton” applies the
initial preset DSP of each tone.
• Param A and Param B (page E-88) for the currently selected DSP type appear on the
display. You can adjust these parameters using
3
K1 and K2.
• Pressing
7
EDIT while this screen is displayed will change to the DSP editing screen
(page E-39).
ton
Preset: 0-0 to 9-9
User: 0-0 to 9-9
Master EQ >Ent Master equalizer setting group (item (5) of the “Effect Block Diagram” on page E-37)
EQ Enable Turning this setting off disables the Master EQ setting. Off, On
Low Freq Low frequency band. Adjusts the low frequency band.
200Hz, 400Hz,
800Hz
Low Gain Low gain. Adjusts the low gain. –12 to 0
*
to +12
Mid1 Freq Mid 1 frequency band. Adjusts the mid1 frequency band. 1.0kHz to 5.0kHz
Mid1 Gain Mid1 gain. Adjusts the mid gain. –12 to 0
*
to +12
Mid2 Freq Mid 2 frequency band. Adjusts the mid2 frequency band. 1.0kHz to 5.0kHz
Mid2 Gain Mid2 gain. Adjusts the mid2 gain. –12 to 0
*
to +12
High Freq High frequency band. Adjusts the high frequency band.
6.0kHz, 8.0kHz,
10.0kHz
High Gain High gain Adjusts the high gain. –12 to 0
*
to +12