Filter
Top Products
107
Basic functions
Saving dataLoading dataProgram
settings
Combination
settings
Producing
songs
Sampling
settings
Creating a
CD
SMF
playback
System
settings
Drum kit
settings
Arpeggiator
settings
Effects
settings
Other
functions
2 Record a sample.
The recorded sample will automatically be assigned to
the index you created in step 1.
3 Repeat steps 1 and 2.
This is an efficient way to record multiple samples.
(☞p.39)
Applying an insert effect to a sample
and resampling it
The process of applying an insert effect etc. to a sampled
sound and then sampling it once again is called “resam-
pling.”
1 In the P0: Recording, Recording page, assign the sam-
ple that you want to resample to “Sample Select.”
When the power is first turned on, the assigned sample
will be set to “Orig.Key” C2.
If you want to resample in stereo, set “Sample Mode”
to Stereo.
2 In P2: Loop Edit, check the “+12 dB” setting.
By making the following settings, you will be able to
resample at the optimal level.
If “+12 dB” is not checked:
“Recording Level”: +0.0 (dB)
(P0: Recording, Recording page)
“Auto +12 dB On”: Off (unchecked)
(P0: Recording, Preference page)
If “+12 dB” is checked:
“Recording Level”: –12 dB (dB)
(P0: Recording, Recording page)
“Auto +12 dB On”: Off (checked)
(P0: Recording, Preference page)
3 In the P0: Recording, Input/Setup page, set “Resam-
ple” to Auto.
Use “Key” to specify the sample that will be resam-
pled. Set this to C2.
Since we will not be sampling from an external input,
set “BUS (IFX/Indiv.) Select” to Off for each Input.
4 In the P8: Insert Effect, Routing page, set “BUS (IFX)
Select” to IFX1.
5 In the P8: Insert Effect, Insert FX page, set “IFX1” to
052: Reverb Hall, and turn “IFX On/Off” ON.
Press the C2 key, and verify that reverb is applied.
6 Press the SAMPLING [REC] key, and then the SAM-
PLING [START/STOP] key.
The sample that is assigned to C2 will play back, and
resampling will start.
When the sample finishes playing, resampling will
end.
The sample that was created by resampling will auto-
matically be assigned to “Sample Select.”
7 Press the C2 key, and verify that reverb is applied.
In Sampling mode, the P8: Insert Effect, Routing page
“BUS (IFX) Select” parameter will automatically be
set to L/R when resampling ends. This prevents an
insert effect from being applied in duplicate when
you monitor the results of resampling through an
insert effect.
If you want to apply an insert effect once again, re-
select IFX1.
As an alternative to automatically resampling as
described above (“Resample” Auto), you can simply
sample the sounds that you play from the keyboard
(“Resample” Manual).