Filter
Top Products
145
Basic functions
Saving dataLoading dataProgram
settings
Combination
settings
Producing
songs
Sampling
settings
Creating a
CD
SMF
playback
System
settings
Drum kit
settings
Arpeggiator
settings
Effects
settings
Other
functions
Other functions
Setting the function of [SW1] and
[SW2]
You can specify the function of the [SW1] and [SW2] keys
(☞PG p.249).
The function of the [SW1] and [SW2] keys can be specified
independently for each program, each combination, and
each song. These functions can also be set independently
for the entire mode in Sampling mode and Song Play
mode.
You can specify the function that will be performed by the
[SW1] and [SW2] keys, and can also select between Toggle
(when the function will be switched on/off each time the
[SW1] or [SW2] key is pressed) and Momentary (when the
function will be on only while you continue holding the
[SW1] or [SW2] key).
These settings are made by Panel Switch Assign in the fol-
lowing pages.
An example of settings in a program
When you write a program or combination, the on/
off status of the [SW1] and [SW2] keys is memorized.
You can use these keys as alternate modulation or
effect dynamic modulation sources, and control pro-
gram parameters or effect parameters.
In this case, you will normally select SW1
Mod.:CC#80 and SW2 Mod.:CC#81.
For an example in which the [SW1] key is specified as an
effect dynamic modulation source for a program and used
to control an effect, refer to p.144.
If you wish to keep these settings after the power is
turned off, you must save them (☞p.56). However,
the settings of Sampling mode cannot be saved.
Setting the B-mode functions of
REALTIME CONTROLS [1]–[4]
You can specify the B-mode functions of REALTIME
CONTROLS knobs [1]–[4] (☞PG p.250).
The B-mode functions can be specified independently for
each program, each combination, and each song. These
functions can also be set independently for the entire
mode in Sampling mode and Song Play mode.
These settings are made in Realtime Control Knobs B-
Assign of the respective page. (☞”Specifying the function
of [SW1] and [SW2]”)
You can use these knobs as sources for alternate mod-
ulation or effect dynamic modulation, and control
program parameters or effect parameters.
In this case, you will normally select Knob
Mod.1:CC#17, Knob Mod.2:CC#19, Knob
Mod.3:CC#20, and Knob Mod.4:CC#21.
Here we will give an example of how knob [1] can be used
to control the filter and amp EG attack of a program.
1 Press the [PROG] key to enter Program mode.
2 After pressing the [MENU] key, and press the P1:
Edit-Basic.
3 Press the Controller tab.
4 Press the Realtime Control Knob B-Assign “Knob 1-
B” popup button, and select F/A Attack.
5 Press the [REALTIME CONTROLS] key to select B-
mode, and rotate knob [1]. The EG attack of the filter
and amp will change.
If you wish to keep these settings after the power is
turned off, you must save them (☞p.56). However,
the settings of Sampling mode cannot be saved.
Adjusting the contrast (brightness)
of the LCD screen
Use the rear panel contrast knob to make adjustments.
Program P1: Edit-Basic, Controller Setup
Combination P4: Edit-Zonr/Ctrl, Control
Song P4: Zonr/Ctrl, Controller Setup
Sampling mode P4: Controller Setup
Song Play mode P2: Controller Setup