Korg sampler Musical Instrument User Manual


 
76
Layer, split, and velocity switch
Within a combination, you can use key position and veloc-
ity to determine which program will sound.
The programs assigned to each timbre can sound in three
ways: as part of a layer, a split, or a velocity switch. A
combination can be set to use any one of these methods,
or to use two or more of these methods.
Layer
Layer refers to settings which cause two or more pro-
grams to sound simultaneously when a note is played.
Split
Split refers to settings which cause different programs to
sound on different areas of the keyboard.
Velocity switch
Velocity Switch refers to settings which cause different
programs to sound depending on the velocity (keyboard
playing dynamics).
On TRITON STUDIO, you can use a different program for
each of up to eight timbres, and combine two or more of
the above methods to create even more complex setups.
As an additional possibility, you can set the slope for a key
zone or velocity zone so that the volume diminishes grad-
ually. This lets you change a split into a keyboard cross-
fade, or a velocity switch into a velocity crossfade.
The Compare function
As you are editing a combi, you can use the [COMPARE]
key to listen to the previously saved version (as it was
before you began editing). Pressing [COMPARE] again
(the light goes dark) returns you to the version you are
editing.
If you continue editing when the [COMPARE] key
LED is lit, the LED will go dark, and the current set-
ting will now be the sound that is recalled when the
[COMPARE] key LED is dark.
Timbre 18 program, pan and volume
P1: Edit-Program/Mixer
Here you can assign programs to each timbre 1–8, and set
the pan and volume for each one. (These settings can also
be made in the Program Select and Mixer pages of P0:
Play.)
Edit-Program/Mixer page
Category, Program Select (Bank/Program)
Assigns a program to each timbre.
When the “Bank/Timbre Program” select menu is
displayed, you can select programs by bank.
When the “Category/Timbre Program” select menu
is displayed, you can select programs from the 16 cat-
egories. (p.35)
You can also use the BANK [INT-A]–[EXB-G] keys to
select the bank of the program.
If you wish to select programs by receiving MIDI pro-
gram changes, do so in P0: Play.
Pan
Specifies the panning (stereo position) for each timbre. A
setting of C064 will reproduce the oscillator pan setting of
the program. Adjusting this parameter will move the
sound to left or right while preserving the pan relation-
ship between the oscillators. A setting of L001 is far left,
and R127 is far right.
Volume
Adjusts the volume of each timbre.
Create the overall sound by adjusting the volume balance
between timbres. The “Volume” setting is an important
aspect of creating the sound, and this setting will have a
significant effect on the overall impression produced by
the Combination.
Program B
Program A
Layer:
Two or more programs sound
simultaneously.
Program B
Program A
Split:
Different programs will sound in
different areas of the keyboard.
Program A
Program B
Keyboard playing
dynamics
Strong
Soft
Velocity Switch:
Keyboard playing dynamics
(velocity) switches between
different programs.
Program C
Program D
Program B
Program A
Keyboard playing
dynamics
Strong
Soft
Example:
B and C/D are split. In the lower
keyboard range, A and B are
layered. In the higher keyboard
range, C and D are switched by
velocity and layered with A.
Program A
Program B
Keyboard X-Fade (keyboard
crossfade):
As you play from low notes
to high notes, the volume of
A will fade out, and the
volume of B will fade in.