Filter
Top Products
2:1 OSC 1 (02: Comb Filter)
Level (Input Wave Level) [0…99]
Specifies the volume level of the signal that will be input to the comb filter.
Noise Level [0…99]
This parameter will be available only if “Input” has been set to OSC2(1)+Noise, SubOSC+Noise, Filter1+Noise
or Filter2+Noise. It specifies the volume level of the noise generator output which will be input to the comb
filter.
Pulse Width [0…99]
This parameter will be available only if “Input” has been set to Pulse Noise or Impluse. It specifies the length
of time that the Pulse Noise or Impluse will last after being triggered.
2–1b: Level Modulation
AMS (Alternate Modulation Source) [OFF…MIDI (CC#83)]
Selects a modulation source (
☞
page 64 of this manual) that will control the volume level of the signal being
input to the comb filter. The volume level is set by the “Level” or the “Noise Level.”
Intensity (Input Wave Level AMS Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.”
2–1c: Feedback
Feedback [0…99]
Specifies the amount of feedback for the comb filter. If this value is high, the resonance of the comb filter will be
high, and the tone will have a clear sense of pitch. Conversely, if this value is low, the input signal will be
output without change, and if the input signal is only noise, the output signal will have no sense of pitch.
AMS.1 (Alternate Modulation Source 1) [OFF…MIDI (CC#83)]
Selects a modulation source 1 (
☞
page 64 of this manual) that will control “Feedback.”
Intensity (Feedback AMS.1 Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.1 .”
AMS.2 (Alternate Modulation Source 2) [OFF…MIDI (CC#83)]
Selects a modulation source 2 (
☞
page 64 of this manual) that will control “Feedback.”
Intensity (Feedback AMS.2 Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.2 .”
2–1d: High Damp
High Damp [0…99]
Specifies the amount of attenuation that will be applied to the high-frequency component of the feedback signal
within the comb filter.
As this value is increased, the tone will become more mellow. Conversely, decreasing this value will produce
a brighter tone.
AMS (Alternate Modulation Source) [OFF…MIDI (CC#83)]
Selects a modulation source (
☞
page 64 of this manual) that will control “High Damp.”
Intensity (High Damp AMS Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.”