Filter
Top Products
Program Edit P4
Here, you can make volume-related settings.
There are two independent amps, and the signals which are input to each amp are determined by the
setting of “3-2a: Routing” (
☞
page 47 of this manual).
4–1: Amp
4–1a: Amp 1
Amplitude [0…99]
Specifies the volume level of amp 1. The input signal to amp 1 is determined by the “3-2a:Routing” setting
EG (Amplitude Modulation EG) [EG1…EG4, Amp EG]
Selects the EG that will create time-variant change in the volume level of amp 1. For the settings of each EG,
refer to “Program Edit P5.”
AMS (Alternate Modulation Source) [OFF…MIDI (CC#83)]
Selects a modulation source (
☞
page 64 of this manual) that will control the volume level of amp 1.
Intensity (Amplitude AMS Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS” on the volume level.
4–1b: Keyboard Track (Amplitude 1 Keyboard Track)
Low Key [C-1…G9]
Specifies the key at which Lower keyboard tracking will begin.
High Key [C-1…G9]
Specifies the key at which Higher keyboard tracking will begin.
Low Int. [–99…+99]
Specifies the way in which keyboard tracking will affect the volume of notes below the Low Key.
4-1: Amp
Parameters
Prog.
Edit
P4
4–1a
4–1b
4–1c
4–1d
4–1e