Filter
Top Products
2:1 OSC 1 (12: Plucked String Model)
Parameters
Prog.
Edit
P2
Dispersion [0…99]
Specifies the inharmonicity of the higher partials relative to the fundamental. With a value of 0, the partials will
be located at integer (whole number) multiples of the fundamental. As this value is increased, the partials will
move further away from integer multiple locations. In general, thin and flexible strings can be simulated by a
low “Dispersion” value, and thick and stiff strings can be simulated by a high “Dispersion” value.
If this value is raised excessively, the pitch may become unstable.
AMS (Alternate Modulation Source) [OFF…MIDI (CC#83)]
Selects a modulation source (
☞
page 64 of this manual) that will control “Dispersion.”
Intensity (Dispersion AMS Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.”
2–1d: Harmonics
Position [0…99]
Specifies the location at which the string will be pressed to play harmonics.
Control [OFF…MIDI (CC#83)]
Selects a modulation source (
☞
page 64 of this manual) that will control the harmonics effect.
Intensity (Harmonics Control Intensity) [–99…+99]
Specifies the depth and direction of the control that “AMS” will have on the harmonics effect.
When making the Position setting, you must assign Control to a controller other than OFF, and raise the
Intensity value. The decay time of the harmonics effect will differ depending on the keyboard location that
you play.
2–1e: Pickup
Pickup
If this is checked, the sound will be passed through a simulated pickup. If this is not checked, the sound will
remain unchanged.
Position, AMS, and Intensity can be set when Pickup has been checked.
Position [0…99]
Adjusts the change in tone that results from differences in pickup location.
AMS (Alternate Modulation Source) [OFF…MIDI (CC#83)]
Selects a modulation source (
☞
p64) that will control “Pickup.”
Intensity (Pickup Position AMS Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.”
2–1f: Low EQ
Frequency [0…49]
Specifies the cutoff frequency of the Low EQ.
Gain [–18…+18]
Specifies the gain of the Low EQ.
Low Boost [0…99]
Specifies how the low frequency range will be emphasized. Raising this value will cause the low frequency
range to be emphasized more strongly.