Filter
Top Products
Data
Precautions
Regarding program change (MIDI) reception
Depending on the oscillator type used by a program, some time may be required after a program change is
received until a bank M program is actually selected. When selecting programs, please leave ample time between
the program change and the following note-on.
Regarding noise
The effect settings and the parameter settings of the oscillator used by the program may affect each
other so as to cause noise to appear in the sound. Also, if a program is played immediately (less than
one second) after it is selected, noise may appear in the output sound.
Data dump compatibility
The bank M programs created using MOSS are not compatible with the Prophecy or Z1.
Please use an insertion effect with the program
In all modes (Program, Combination, Sequencer), be sure to use an insertion effect when using a bank M program.
If you do not use an insertion effect, the output of the bank M program will diminish.
When MIDI Clock Source is set to Internal
If a bank M program is selected for any timbre in a combination, the D-mod Src “Tempo” for the AMS or effect
of the timbre program will use the Prog. Tempo setting (
☞
page 61 of this manual).
SOLO-TRI convert sounds (SOLO_TRI.PCG)
The SOLO_TRI.PCG sounds in the included disk are data which was created to allow the SOLO-TRI
preset sounds (
☞
page 14 of this manual) to be simulated on the MOSS-TRI. For some sounds, the
audible result may not be precisely identical.
Additional message
Bank S was skipped
Situation: Bank S data was skipped while loading data. Bank S programs cannot be used.