Filter
Top Products
2:1 OSC 1 (10: Brass Model)
Parameters
Prog.
Edit
P2
2–1a: Inst Type
Inst Type [Brass 1, Brass 2, Brass 3, Horn 1, Horn 2, Reed Brass]
Selects the instrument type which will determine the bore length and shape of the simulated instrument.
Jump Bend (+X)
Specifies how the pitch will change when the joystick is moved in the +X direction (toward the right).
If this is checked, the pitch will rise by in steps by changing the resonance of the bore, as on a trumpet.
If this is unchecked, the pitch will rise smoothly, as on most synthesizers.
Jump Bend (–X)
Specifies how the pitch will change when the joystick is moved in the –X direction (toward the left).
If Jump Bend (+X) and Jump Bend (–X) are checked, notes may not sound depending on the position of the
joystick and the pitch range setting.
For details on setting the pitch range of the joystick, refer to “1-2c: Bending.”
2–1b: Breath Pressure
EG [EG 1…EG 4, Amp EG]
Selects the EG which will control pressure.
For details on the settings for each EG, refer to “Program Edit P5” for EG 1—4, and “4-2: Amp EG” for Amp EG.
Intensity (Pressure EG Intensity) [–99…+99]
Specifies the depth and direction of the effect that the “EG” will have on the pressure.
AMS.1 (Alternate Modulation Source 1) [OFF…MIDI (CC#83)]
Selects a modulation source 1 (
☞
page 64 of this manual) that will control pressure. If you select After Touch,
pressing down on the keyboard will produce the effect of the instrument being blown strongly. If you select Joy
Stick(X), rotating the Joy Stick in the + direction will produce this effect. In this case, setting “Intensity (Pressure
EG Intensity)” to 0 will allow you to completely control the breath pressure by operating the specified controller.
Intensity (Pressure AMS.1 Intensity) [–99…+99]
Specifies the depth and direction of the change in pressure controlled by “AMS.1.”
AMS.2 (Alternate Modulation Source 2) [OFF…MIDI (CC#83)]
Selects a modulation source 2 (
☞
page 64 of this manual) that will control pressure.
Intensity (Pressure AMS.2 Intensity) [–99…+99]
Specifies the depth and direction of the change in pressure controlled by “AMS.2.”
Breath Noise [0…99]
Specifies the volume level of the breath noise. Since this uses the signal from the noise generator, the filter of the
noise generator can be used to modify the tone of the noise.
Strength [0…99]
Adjusts the tone. Higher settings of this value will produce a overdriven sound.
2–1c: Lip Character
Lip [0…99]
Specifies the tonal change that is produced by lip position and tension. Higher settings of this value will produce a
harder (more firmly blown) sound. Lower settings will produce a softer tone.
AMS (Alternate Modulation Source) [OFF…MIDI (CC#83)]
Selects a modulation source (
☞
page 64 of this manual) that will control “Lip.”
Intensity (Lip Character AMS Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.”