Filter
Top Products
2:1 OSC 1 (04: Resonance)
Parameters
Prog.
Edit
P2
04: Resonance
This oscillator produces a wide range of tonal change by allowing you to specify the cutoff frequency
and resonance of four band pass filters (BPF). You can select one of the following sources to be the
input for the filters: the output of the other oscillator, the sub-oscillator, the output of the noise
generator, or the output of filter 1 or filter 2.
2–1a: Input
Input [OSC2(1), SubOSC, Noise, Filter1, Filter2]
Selects the signal that will be input to the four band bass filters.
If you select 04:Resonance for OSC 1 and 2 in “1-2a: Multi Oscillator Synthesis Setup,” and select the other
oscillator as the input for each, the result will be unstable — the sound may be non-reproduceable, or you
may hear no sound at all.
Level [0…99]
Specifies the level of the signal that is input to the four band pass filters.
AMS.1 (Alternate Modulation Source 1) [OFF…MIDI (CC#83)]
Selects a modulation source 1 (
☞
page 64 of this manual) that will control “Level.”
Intensity (Level AMS.1 Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.1.”
AMS.2 (Alternate Modulation Source 2) [OFF…MIDI (CC#83)]
Selects a modulation source 2 (
☞
page 64 of this manual) that will control “Level.”
Intensity (Level AMS.2 Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.2.”
2–1a
2–1b
2–1c
OSC 1/2
Sub OSC
Noise Generator
BPF2
BPF3
BPF4
BPF1
Resonance1
Coarse1
Level1
Input Level
Input Select
Filter1 out
Filter2 out