Filter
Top Products
2:1 OSC 1 (02: Comb Filter)
AMS.1 (Alternate Modulation Source 1) [OFF…MIDI (CC#83)]
Selects a modulation source 1 (
☞
page 64 of this manual) that will control “Shape” value.
Intensity (Shape AMS.1 Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.1.”
AMS.2 (Alternate Modulation Source 2) [OFF…MIDI (CC#83)]
Selects a modulation source 2 (
☞
page 64 of this manual) that will control “Shape” value.
Intensity (Shape AMS.2 Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.2.”
Type (Wave Shap Type) [1, 2]
1: The signal after wave shaping will be output without further change. If “Shape” is set to the
minimum value, the phase modulated signal will be output essentially without change.
2: A rounded waveform will be obtained regardless of the “Shape” value.
2–1c: Feedback [0…99]
Specifies the amount of the output after wave shaping that will be fed back to the carrier.
2–1d: Modulator
Wave [Saw, Square, Triangle, Sine, OSC2(1), SubOSC, Filter1, Filter2]
Selects the modulator waveform.You may select the other oscillator or the sub oscillator, etc.
If you select OSC 2(1), SubOSC, Filter 1, or Filter 2, it will not be possible to set “2-1e: Frequency.”
Level [0…99]
Specifies the output level of the modulator.
This value will determine the amount of modulation that is applied to the “2-1a: Carrier” setting.
AMS.1 (Alternate Modulation Source 1) [OFF…MIDI (CC#83)]
Selects a modulation source 1 (
☞
page 64 of this manual) that will control “Level.”
Intensity (Level AMS.1 Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.1.”
AMS.2 (Alternate Modulation Source 2) [OFF…MIDI (CC#83)]
Selects a modulation source 2 (
☞
page 64 of this manual) that will control “Level.”
Intensity (Level AMS.2 Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.2.”
2–1e: Frequency
Coarse [0.5, 1…16]
Specifies a multiplication factor which will be applied to the pitch of the modulator, relative to the “2-1a: Carrier”
setting.
Fine [–50…+50]
Makes fine adjustments to the pitch of the modulator.
AMS.1 (Alternate Modulation Source 1) [OFF…MIDI (CC#83)]
Selects a modulation source 1 (
☞
page 64 of this manual) that will control the pitch of the modulator.
Intensity (Frequncy AMS.1 Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.1.”
AMS.2 (Alternate Modulation Source 2) [OFF…MIDI (CC#83)]
Selects a modulation source 2 (
☞
page 64 of this manual) that will control the pitch of the modulator.
Intensity (Frequncy AMS.2 Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.2.”