Filter
Top Products
2-3: Sub/Noise
2–3b: Noise Generator
Here, you can make various settings for the noise generator.
Filter Type [Thru, Low Pass, High Pass, Band Pass]
Selects the type of filter that will be applied to the output of the noise generator.
When Thru is selected, the Input Trim, Frequency, AMS.1, Intensity (Cutoff Frequency AMS.1 Intensity), AMS.2,
Intensity (Cutoff Frequency AMS.2 Intensity), and Resonance settings will be unavailable.
Input Trim [0…99]
Specifies the input level to the dedicated noise filter.
Cutoff Frequency [0…99]
Specifies the cutoff frequency of the noise signal filter. For the characteristics of each filter type, refer to “3-
2b:Filter1” (
☞
page 47 of this manual).
AMS.1 (Alternate Modulation Source 1) [OFF…MIDI (CC#83)]
Selects a modulation source 1 (
☞
page 64 of this manual) that will control the “Cutoff Frequency.”
Intensity (Cutoff Frequency AMS.1 Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.1.”
AMS.2 (Alternate Modulation Source 2) [OFF…MIDI (CC#83)]
Selects a modulation source 2 (
☞
page 64 of this manual) that will control the “Cutoff Frequency.”
Intensity (Cutoff Frequency AMS.2 Intensity) [–99…+99]
Specifies the depth and direction of the effect of “AMS.2.”
Resonance [0…99]
This boosts the frequency region specified by the “Cutoff Frequency” to add character to the sound. Since the
filter characteristics differ from the filter type of the “3-2b: Filter 1 ,” “3-4b: Filter 2” the resulting effect will be
different even if “Type,” “Cutoff Frequency” and “Resonance” settings are identical.