Filter
Top Products
6–1d: Amplitude Modulation
AMS (Alternate Modulation Source 1) [OFF…MIDI (CC#83)]
Selects a modulation source (
☞
page 64 of this manual) that will control the amplitude of the LFO waveform.
Intensity (Amplitude AMS Intensity) [–99…+99]
Specifies the depth and direction of the effect that “AMS” will have on the amplitude of the LFO waveform.
Offset [–50…+50]
Specifies the center value of the LFO waveform.
Fade In Time [0…99]
Specifies the time over which the amplitude of the LFO will increase from 0 until it reaches the maximum
value.
6–2: LFO 2
6–3: LFO 3
6–4: LFO 4
LFO 2, LFO 3, and LFO 4 have the same parameter as LFO 1. Refer to “6-1: LFO 1 ”
6-1: LFO 1, 6-2: LFO 2, 6-3: LFO 3, 6-4: LFO 4
The parameter value
being modulated
LFO movement determined
by Modulation Intensity
The parameter value
being modulated
LFO movement determined
by Modulation Intensity
The parameter value
being modulated
LFO movement determined
by Modulation Intensity
Offset = 0
Offset = 50
Offset = -50
AMSource
AMSource
AMSource