Filter
Top Products
13
Making connections
Turning the power on/off
Turning the power on
• Once the connections have been completed (p. 12), turn on power to
your various devices in the order specified. By turning on devices in the
wrong order, you risk causing malfunction and/or damage to speakers
and other devices.
• This unit is equipped with a protection circuit. A brief interval (a few
seconds) after power up is required before the unit will operate
normally.
• Turn the volume down before you turn on the power. You may hear
sound from the headphones when you turn on the power, but this is not
a malfunction.
1
Make sure that the volume controls of the MC-09 and all
connected devices are turned to the minimum position.
2
Turn on the power of the device connected to the INPUT jacks.
3
Turn on the power of the MC-09.
4
Turn on the power of the device connected to the OUTPUT jacks.
5
Adjust the volume of all devices.
On the MC-09, the volume is affected by three types of knob or control. You
will need to adjust these as appropriate.
OUTPUT knob: This adjusts the overall volume of the MC-09.
LEVEL knob: This adjusts the volume from the device connected to
the INPUT jacks and the volume of the DSP
synthesizer.
Part volume sliders: These adjust the volume of each audio looper part.
* In some cases, there will be no sound if any of these knobs are set to the minimum
position.
Turning the power off
To turn off the power, make sure that the volume controls of the MC-09 and
all connected devices are turned to the minimum position, and turn off the
power of each device in the opposite order of that used when you turned
them on.