Filter
Top Products
52
Changing the way in which a loop plays (Loop Control)
Realtime performance using Trigger
You can play parts 1–4 by pressing the step [1]–[4] buttons. This is
convenient for live performance.
1
Load the loop that you want to play into part 1–4 (p. 59).
2
Press the [LOOP CTRL] button so its indicator lights.
Loop control will be turned on.
3
Press the [DISPLAY] button so the TONE/TYPE indicator lights.
4
Press the [INC] or [DEC] button to get the “” display.
5
Press the step [1]–[4] button for the part you want to play.
While you hold down the step [1]–[4] button, the corresponding part will
sound. However, it will not play back repeatedly.
6
When you are finished with trigger performance, press the
[LOOP CTRL] button so the indicator goes out.
Realtime performance using Divide times 16
You can play each divided section of the sound by pressing the step [1]–[16]
buttons. This lets you recreate a loop as a new performance.
1
Load the loop that you want to play into part 1 (p. 59).
2
Press the [LOOP CTRL] button so its indicator lights.
Loop control will be turned on.
3
Press the [DISPLAY] button so the TONE/TYPE indicator lights.
4
Press the [INC] or [DEC] button until “” appears in the
display.
The loop will be divided into 16 or 12 sections.
If you want to divide the
loop into 12 sections, press
the [SETUP] button, then
press the [SCALE] button
so its indicator lights.