Filter
Top Products
51
Changing the way in which a loop plays (Loop Control)
Using loop control for realtime performance
Realtime pitch performance
You can use the step [1]–[16] buttons to play part 1 at different pitches.
* There will be no sound if you exceed a range of one octave higher or lower than the
original pitch of part 1.
1
Load the loop that you want to play into part 1 (p. 59).
2
Press the [LOOP CTRL] button so its indicator lights.
Loop control will be turned on.
3
Press the [DISPLAY] button so the TONE/TYPE indicator
lights.
4
Press the [INC] or [DEC] button to get the “” display.
5
Perform the sound by pressing the step [1]–[16] button
corresponding to the desired pitch.
While you press a step [1]–[16] button, part 1 will play at the pitch
corresponding to the button you pressed. However, it will not play
repeatedly.
The step [1]–[16] buttons correspond to different pitches as follows.
fig.pitchplay
6
When you are finished with realtime pitch performance, press
the [LOOP CTRL] button so the indicator goes out.
Octave shift