Filter
Top Products
102
Chapter 2 Using the XV-5080 Effects
Chorus/Flanger
Type
Selects either Chorus or Flanger.
Rate
Sets the modulation speed for the chorus or flanger.
Depth
Sets the modulation depth for the chorus or flanger.
Feedback (CF Feedback)
Adjusts the proportion (%) of the flanger sound that is fed
back into the effect. Negative (-) settings will invert the
phase.
Pre Dly (Chorus/Flanger Pre Delay Time)
Adjusts the delay time from the direct sound until when the
chorus sound is heard.
Balance #
Adjusts the volume balance between the direct sound and
the chorus/flanger sound.
Filter
Type (Filter Type)
Selects the type of filter.
OFF: No filter is used.
LPF: The frequency region above the Cutoff Freq setting will
be cut.
HPF: The frequency region below the Cutoff Freq setting will
be cut.
Cutoff (Cutoff Frequency)
Sets the cutoff frequency when a specific frequency band is
cut off by a filter.
Output
Level (Output Level)
Adjusts the output level.
Pan (Output Pan) #
Adjusts the stereo location of the output sound.
86: BASS MULTI
Bass Multi provides Compressor (Comp), Overdrive or
Distortion (OD/Dist), Equalizer (3 Band EQ), and Chorus or
Flanger (Cho/Flg) effects connected in series.
fig.02-086m.e
Sequence
Comp (Compressor Switch)
Turns the Compressor on/off.
OD/Dist (Overdrive or Distortion Switch)
Turns the Overdrive or Distortion on/off.
Amp Sim (Amp Simulator)
Turns the Amp Simulator on/off.
3 Band EQ (3 Band EQ Switch)
Turns the 3 Band EQ on/off.
Cho/Flg (Chorus/Flanger Switch)
Turns the Chorus/Flanger on/off.
Compressor
Attack (Compressor Attack)
Specifies the duration of the attack when sound is input.
Sustain (Compressor Sustain)
Specifies the time over which low-level sounds will be
boosted to reach the specified volume. Increasing the value
will shorten the time.
* When the value is modified, the level will also change.
Level (Compressor Level) #
Sets the volume of the compressor sound.
Overdrive/Distortion
Type
Selects either Overdrive or Distortion.
Drive #
Adjusts the degree of distortion. The volume will change
L out
R out
L in
R in
Compressor
3-Band
EQ
Overdrive/
Distortion
Amp
Simulator
Chorus/
Flanger