Filter
Top Products
25
Chapter 2 Using the XV-5080 Effects
Chap.2
The screen appears as shown below, according to the settings
values.
• For MFX
fig.02-004.e_70
• For A–D
fig.02-005.e_70
• For 1–8
fig.02-006.e_70
The following shows the basic setting procedure.
1. Select the Patch you wish to work with.
2. Press [F6 (Effects)].
The Patch Effect page appears.
3. Press [F1 (General)].
The General page will appear.
fig.02-007.e_70
4. Press [ ]/[ ]/[ ]/[ ] to move the cursor to
the parameter you want to set.
5. Turn the VALUE dial, or press [INC]/[DEC] to select the
desired value.
* If you make a mistake when setting a parameter’s value, or you
don’t like the change you have made, just press [UNDO] to
restore the value the parameter originally had.
6. Repeat Steps 3 to 5 to set the Effect.
7. Press [EXIT] to return to the PATCH Play page.
A “*” symbol will appear at the left of the Patch name,
indicating that its settings have been modified.
fig.02-008.e_70
* If you turn off the power or select another Patch while the “*”
symbol is displayed, your new Patch settings will be lost. If
you wish to keep them, perform the Write operation. (p. 194)
* With Multi-Partial Patches, pressing [F6 (MIDISel)] allows
you to select the Partial to be edited from the MIDI keyboard.
* When [MFX], [CHO], or [REV] are turned off, effects
processors that are turned off will be indicated by a dashed
outline in the General page.
* When the General page is accessed, you can press [F6
(Palette)] to view the settings for all four Tones together in a
single screen. This allows you to compare the settings of each
Tone as you make settings. When you press [F6 (
→
Tone 1)],
the General page will reappear. [F6] will display the Tone
number to which you will return.
Split Key Edit Mode
When editing Multi-Partial Patches, this sets the key ranges
to which settings are applied.
Settings Values
1KEY: Settings are made for each key individually.
PTL: Settings are applied to all keys to which corresponding
Partials are assigned.
ALL: Settings are applied to all keys to which all Partials are
assigned.
Routing Tones to Effects
This sets the output destination and level for the currently
selected Tone and Partial, as well as its send level with
respect to the Chorus and Reverb.
On the Effects General page, set the following parameters.
Output Assign
MFX: The Tone is sent into the Multi-effects. Its output
destination is determined by the Multi-effects output
settings.
A–D: The Tone is sent to one of the four output-jack stereo
pairs, OUTPUTS A–D.
1–8: The Tone is sent to the INDIVIDUAL output jacks 1–8.