Filter
Top Products
108
Chapter 3 Selecting Output Jacks
Parameters
The parameters related to Patch output settings are shown
below.
PATCH Effects General page ([PATCH] -
[F6 (Effects)] - [F1 (General)])
This sets the output destination and level for the currently
selected Tone, as well as its send level with respect to the
Chorus and Reverb.
Tone Output Assign
Available Settings:
MFX: The Tone is sent into the Multi-effects. Its output
destination is determined by the Multi-effects output
settings.
OUTPUT A–D: The Tone is sent to one of the four output-
jack stereo pairs, OUTPUTS A–D.
INDIV 1–8: The Tone is sent to the INDIVIDUAL OUTPUT
jacks 1–8.
Tone Dry Send Level
Range: 0–127
Sets the level of the signal to be sent to the OUTPUT jacks,
which is determined by Tone Output Assign.
Tone Chorus Send Level
Range: 0–127
Sets how much of the Tone is sent to the Chorus. Its final
output destination is determined by the Chorus output
setting.
Tone Reverb Send Level
Range: 0–127
Sets how much of the Tone is sent to the Reverb. Its final
output destination is determined by the Reverb output
setting.
MFX Dry Send Level
Range: 0–127
Determines the level of the Multi-effects processor’s output
to the OUTPUT jacks.
MFX Chorus Send Level
Range: 0–127
Determines the level of the post-Multi-effects processor
signal sent to Chorus. Its final output destination is
determined by the Chorus output setting.
MFX Reverb Send Level
Range: 0–127
Determines the level of the post-Multi-effects processor
signal sent to Reverb. Its final output destination is
determined by the Reverb output setting.
Chorus Output Select
Specifies how the signal routed through Chorus will be
output.
Available Settings:
MAIN: The Chorus output is sent only to the OUTPUT jacks.
REV: The Chorus output is sent only to the Reverb.
M+R: The Chorus output is sent to the OUTPUT jacks and to
the Reverb.
Chorus Level
Range: 0–127
Determines the Chorus output level.
Reverb Level
Range: 0–127
Determines the Reverb output level.
MFX Output Assign
Range: A–D
Specifies the OUTPUT jacks to which the signal, after it has
passed through the Multi-effects, is to be routed.
* As the Multi-effects are in stereo, settings for the
INDIVIDUAL OUTPUT jacks are unavailable.
Chorus Output Assign
Range: A–D
Selects the pair of OUTPUT jacks to which the Chorus unit’s
stereo output is routed when Chorus Output Select is set to
“MAIN” or “MAIN+R.” The output destination of the signal
sent to Reverb follows the Reverb setting.
* As the internal effects processors are in stereo, settings for the
INDIVIDUAL OUTPUT jacks are unavailable.
Reverb Output Assign
Range: A–D
Selects the OUTPUT jacks to which the Reverb unit’s stereo
output is routed.
* As the internal effects processors are in stereo, settings for the
INDIVIDUAL OUTPUT jacks are unavailable.