Filter
Top Products
91
Chapter 2 Using the XV-5080 Effects
Chap.2
modified.
250Hz (250Hz Gain)
Specifies the gain (amount of boost or cut) at 250 Hz.
500Hz (500Hz Gain)
Specifies the gain (amount of boost or cut) at 500 Hz.
1000Hz (1000Hz Gain)
Specifies the gain (amount of boost or cut) at 1000 Hz.
2000Hz (2000Hz Gain)
Specifies the gain (amount of boost or cut) at 2000 Hz.
4000Hz (4000Hz Gain)
Specifies the gain (amount of boost or cut) at 4000 Hz.
8000Hz (8000Hz Gain)
Specifies the gain (amount of boost or cut) at 8000 Hz.
Enhancer
Sens (Enhancer Sens)
Adjusts the sensitivity of the enhancer.
Mix Level #
Determines the proportion at which the overtones generated
by the enhancer will be mixed with the original sound.
Output
Level (Output Level)
Adjusts the output level.
Pan (Output Pan)
Adjusts the stereo location of the output sound.
76: STEREO LOFI COMPRESS
This is a stereo Lo-Fi compress. This is an effect that
intentionally degrades the sound quality.
fig.02-076m.e
Lo-Fi
Type (LoFi Type)
Degrades the sound quality. The sound quality will become
poorer as this value is increased.
Pre Filter
Type
Specifies the type of filter that will be applied before the
sound passes through the Lo-Fi effect.
Post Filter 1
Type
Specifies the type of filter that will be applied after the sound
passes through the Lo-Fi effect.
Post Filter 2
Type
OFF: A post filter 2 will not be used.
LPF: The frequency region above the Cutoff Freq setting will
be cut.
HPF: The frequency region below the Cutoff Freq setting will
be cut.
Cutoff (Cutoff Frequency)
Sets the cutoff frequency when a specific frequency band is
cut off by a filter.
EQ Gain
Low (Low Gain)
Adjusts the gain of the low frequency range.
Positive (+) settings will emphasize (boost) the low-
frequency range.
High (High Gain)
Adjusts the gain of the high frequency range.
Positive (+) settings will emphasize (boost) the high-
frequency range.
Balance
Balance #
Sets the volume balance between the direct sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the effect sound
will be output.
Output
Level (Output Level)
Adjusts the output level.
L in
R in
L out
R out
Lo-Fi
2-Band EQ
2-Band EQ
Lo-Fi