Filter
Top Products
35
Chapter 2 Using the XV-5080 Effects
Chap.2
• For Type: 2 (SRV ROOM)/3 (SRV
HALL)/4 (SRV PLATE)
Pre Delay (Pre Delay Time) 0.0–100 ms
Adjusts the time delay from when the direct sound begins
until the reverb sound is heard.
Time (Reverb Time) 0–127
Adjusts the time length of reverberation.
Size 1–8
Adjusts the size of the simulated room or hall. The size
becomes bigger as the value increases.
High Cut (High Cut Frequency) *1
Sets the frequency above which the high-frequency content
of the reverb will be reduced. If you do not want to damp the
high frequencies, set this parameter to BYPASS.
Density (Reverb Density) 0–127
Adjusts the density of reverb. Higher values result in greater
density.
Diffusion (Reverb Diffusion) 0–127
Adjusts the change in the density of the reverb over time. The
higher the value, the more the density increases with time.
(The effect of this setting is most pronounced with long
reverb times.)
LF Damp Freq (LF Damp Frequency) *2
Specifies the frequency below which the low-frequency
content of the reverb sound will be reduced, or “damped.”
LF Damp Gain -36–0 dB
Adjusts the amount of damping applied to the frequency
range selected with LF Damp. With a setting of “0,” there
will be no reduction of the reverb’s low-frequency content.
HF Damp Freq (LF Damp Frequency) *3
Specifies the frequency above which the high-frequency
content of the reverb sound will be reduced, or “damped.”
HF Damp Gain -36–0 dB
Adjusts the amount of damping applied to the frequency
range selected with HF Damp. With a setting of “0,” there
will be no reduction of the reverb’s high-frequency content.
*1 160, 200, 250, 320, 400, 500, 640, 800, 1000, 1250, 1600,
2000, 2500, 3200, 4000, 5000, 6400, 8000, 10000, 12500
Hz, BYPASS
*2 50, 64, 80, 100, 125, 160, 200, 250, 320, 400, 500, 640, 800,
1000, 1250, 1600, 2000, 2500, 3200, 4000 Hz
*3 4000, 5000, 6400, 8000, 10000, 12500 Hz