Filter
Top Products
97
Chapter 2 Using the XV-5080 Effects
Chap.2
Amp Sim (Amp Simulator Switch)
Turns the Amp Simulator on/off.
3 Band EQ (3 Band EQ Switch)
Turns the equalizer on/off.
Cho/Flg (Chorus/Flanger Switch)
Turns the chorus/flanger on/off.
Compressor
Attack (Compressor Attack)
Specifies the duration of the attack when sound is input.
Sustain (Compressor Sustain)
Specifies the time over which low-level sounds will be
boosted to reach the specified volume. Increasing the value
will shorten the time. When the value is modified, the level
will also change.
Level (Compressor Level) #
Sets the volume of the compressor sound.
Overdrive/Distortion
Type
Selects either Overdrive or Distortion.
Drive #
Adjusts the degree of distortion. The volume will change
together with the degree of distortion.
Tone (Overdrive/Distortion Tone)
Adjusts the sound quality of the Overdrive/Distortion effect.
Level
Sets the volume of the overdrive sound.
Amp Simulator
Type (Amp Simulator Type)
Selects the type of guitar amp.
Small: small amp
BltIn: built-in type amp
2-Stk: large double stack amp
3-Stk: large triple stack amp
EQ Gain
Low (EQ Low Gain)
Adjusts the low-range gain of the equalizer.
Mid (EQ Mid Gain)
Adjusts the gain of the area specified by the EQ M Fq
parameter and the EQ M Q parameter.
High (EQ High Gain)
Adjusts the high-range gain of the equalizer.
Mid
Mid (EQ Mid Frequency)
Sets the center frequency for the equalizer mid-range.
Mid Q (EQ Mid Q)
Adjusts the width of the area centered at the EQ M Fq setting
in which the gain will be affected. Higher values of Q will
result in a narrower area being affected.
Chorus/Flanger
Type
Selects either Chorus or Flanger.
Rate
Sets the modulation speed for the chorus or flanger.
Depth
Sets the modulation depth for the chorus or flanger.
Feedback
Adjusts the proportion (%) of the flanger sound that is fed
back into the effect. Negative (-) settings will invert the
phase.
Pre Delay (Chorus/Flanger Pre Delay Time)
Adjusts the delay time from the direct sound until when the
chorus sound is heard.
Balance #
Adjusts the volume balance between the direct sound and
the chorus/flanger sound.
Filter
Type (Filter Type)
Selects the type of filter.
OFF: No filter is used.
LPF: The frequency region above the Cutoff Freq setting will
be cut.
HPF: The frequency region below the Cutoff Freq setting will
be cut.