Filter
Top Products
73
Chapter 2 Using the XV-5080 Effects
Chap.2
HPF:The frequency region below the Cutoff Freq setting will
be cut.
Cutoff (Cutoff Frequency)
Adjust the frequency at which the filter will begin cutting.
Radio Noise
Detune #
Simulates the tuning noise of a radio. As this value is raised,
the tuning will drift further.
Level
Adjust the volume of the radio noise.
Disc Noise
Type (Disc Noise Type)
Selects the type of record noise. The frequency at which the
noise is heard will depend on the selected type.
LPF
Adjust the cutoff frequency of the low pass filter that is
applied to the record noise.
Level (Disc Noise Level)
Adjust the volume of the record noise.
EQ Gain
Low (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
High (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance
Balance (Effect Balance) #
Sets the volume balance between the source sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the effect sound
will be output.
Output
Level (Output Level)
Adjust the output level.
Pan (Output Pan)
Adjust the stereo position of the delay sound. A setting of
L64 is far left, 0 is center, and 63R is far right.
52:SPEAKER SIMULATOR
Speaker Simulator is an effect that simulates the speaker type
and mic settings used to record the speaker sound.
fig.2-62
Speaker
Type (Speaker Type)
Select the type of speaker. The specifications of each type are
as follows. The speaker column indicates the diameter of
each speaker unit (in inches) and the number of units.
Type Cabinet SpeakerMicrophone
SMALL 1 small open-back enclosure 10 dynamic mic
SMALL 2 small open-back enclosure 10 dynamic mic
MIDDLE open back enclosure 12 x 1 dynamic mic
JC-120 open back enclosure 12 x 2 dynamic mic
BUILT IN 1 open back enclosure 12 x 2 dynamic mic
BUILT IN 2 open back enclosure 12 x 2 condenser mic
BUILT IN 3 open back enclosure 12 x 2 condenser mic
BUILT IN 4 open back enclosure 12 x 2 condenser mic
BUILT IN 5 open back enclosure 12 x 2 condenser mic
BG STACK 1 sealed enclosure 12 x 4 condenser mic
BG STACK 2 large sealed enclosure 12 x 4 condenser mic
MS STACK 1 large sealed enclosure 12 x 4 condenser mic
MS STACK 2 large sealed enclosure 12 x 4 condenser mic
METAL STACK large double stack 12 x 4 condenser mic
2-STACK large sealed enclosure 12 x 4 condenser mic
3-STACK large sealed enclosure 12 x 4 condenser mic
Mic
Setting (Mic Setting)
Adjust the location of the mic that is recording the sound of
the speaker. This can be adjusted in three steps, with the mic
becoming more distant in the order of 1, 2, and 3.
Level #
Adjust the volume of the microphone.
Direct Level #
Adjust the volume of the direct sound.
L in
R in
L out
R out
Speaker
Speaker