Filter
Top Products
92
Chapter 2 Using the XV-5080 Effects
77: STEREO LO-FI NOISE
This is a stereo Lo-Fi noise. In addition to a Lo-Fi effect, this
effect also generates various types of noise such as radio
noise and disc noise.
fig.02-077m.e
Lo-Fi
Type
Degrades the sound quality. The sound quality will become
poorer as this value is increased.
Hum
Type (Hum Noise Type)
Selects the type of hum noise.
LPF (Hum Noise LPF)
Specifies the cutoff frequency of the low pass filter that is
applied to the hum noise.
Level (Hum Noise Level)
Specifies the volume of the hum noise.
Post Filter
Type (Post Filter Type)
OFF: No filter is used.
LPF: Frequencies higher than the selected cutoff frequency
value are eliminated.
HPF: Frequencies lower than the selected cutoff frequency
value are eliminated.
Cutoff (Post Filter Cutoff Frequency)
Sets the cutoff frequency when a specific frequency band is
cut off by a filter.
Disc Noise
Disc Noise Type
Selects the type of record noise. The frequency at which the
noise is heard will depend on the selected type.
Disc Noise LPF
Specifies the cutoff frequency of the low pass filter that is
applied to the record noise.
Disc Noise Level
Specifies the volume of the record noise.
Radio Noise
Detune (Radio Detune) #
Simulates the tuning noise of a radio. As this value is raised,
the tuning will drift further.
Level (Radio Noise Level)
Specifies the volume of the radio noise.
Noise
Noise Type
Selects either white noise or pink noise.
LPF (White/Pink Noise LPF)
Specifies the cutoff frequency of the low pass filter that is
applied to the white noise or pink noise.
Level (White/Pink Noise Level)
Specifies the volume of the white noise or pink noise.
EQ Gain
Low (Low Gain)
Adjusts the gain of the low frequency range.
Positive (+) settings will emphasize (boost) the low-
frequency range.
High (High Gain)
Adjusts the gain of the high frequency range.
Positive (+) settings will emphasize (boost) the high-
frequency range.
Balance
Balance #
Sets the volume balance between the direct sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W the effect sound will
be output.
R in
R out
L in
L out
Lo-Fi
Lo-Fi
2-Band
EQ
2-Band
EQ
Noise Gen.
Radio