Roland XV-5080. Musical Instrument User Manual


 
55
Chapter 2 Using the XV-5080 Effects
Chap.2
Balance
Balance (Effect Balance) #
Adjust the volume balance between the direct sound and the
delay sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
delay sound will be output.
Output
Level (Output Level)
Adjust the output level.
20: QUADRUPLE TAP DELAY
The Quadruple Tap Delay has four delays. Each of the Delay
Time parameters can be specified as a note length of the
selected tempo.
fig.2-25
The stereo location of each delay sound is as follows.
fig.2-26
Delay
Delay 1 (Delay Time 1)
Delay 2 (Delay Time 2)
Delay 3 (Delay Time 3)
Delay 4 (Delay Time 4)
Adjust the time delay from the direct sound until when each
delay sound is heard. These parameters can be set as a note-
value of a specified tempo. In this case, specify the value of
the desired note.
HF Damp
Adjust the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
Feedback (Feedback Level) #
Adjust the proportion (%) of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
Delay Level
Level 1
Level 2
Level 3
Level 4
Adjust the volume of each delay sound.
Balance
Balance (Effect Balance) #
Adjust the volume balance between the direct sound and the
delay sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
delay sound will be output.
Output
Level (Output Level)
Adjust the output level.
L in
R in
L out
R out
Quadruple Tap Delay
Balance W
Balance D
Balance W
Balance D
Delay 1
Delay 2
Delay 3
Delay 4
Feedback
1
23
4
L
R