Filter
Top Products
IMPORTANT SAFETY PRECAUTIONS
66 TASCAM DP-02/DP-02CF
4 – DP-02 Appendix
The DP-02 is a built-in CD-R/RW drive. The CD-R/RW
functions are described here.
T I P
In the menu instructions below, select menus by press-
ing the ¥ cursor or YES/ENTER key.
Audio CD performance
Playing back audio CDs
1. Insert the audio CD into the slot.
2. Press the CD key to bring up the CD menu screen,
and select the CD PLAYER menu.
3. When entered, the display shows:
The currently selected track is highlighted.
The next track can be selected using the DATA dial
or the cursor (§/¶) keys.
4. Press the PLAY (¥) key to playback the selected
track.
5. When the CD PLAYER menu is displayed, the CD
player can be controlled using the following keys:
STOP key: Stops the CD player.
PLAY (¥) key: Plays back the selected track.
F FWD/≤ keys: Skips the next track.
REW/µ keys : Skips the previous track.
DATA dial: Selects a track to playback from the
track list.
YES/ENTER key: Plays the selected track.
STOP+REW key: Stops playback and locates at
the start of the CD. (Press the REW key with the
STOP key held down.)
•
•
•
•
•
•
•
With the label side up, gently slide in a disc until the unit
pulls the disc in. When the disc has been loaded, the
following CD PLAYER display is shown:
Press the EJECT key to eject the disc.
Inserting/Ejecting CDs
NOTE
When the EJECT key does not work, turn off the power
and carefully push a small stick into the hole under the
CD slot a few times until the CD comes partially out,
and be removed manually.
If the power switch also does not work, disconnect
the power cable from the unit and attempt the same
operation. However, in this case, the unit cannot shut
down properly so that all the data unsaved on CD will
be lost (see “Shouting down the unit” on page 10).
The CD mechanism in this device produces noises
when actions such as Inserting or Ejecting a CD are
performed. Depending on the positions of the LEVEL
controls, these noise may be recorded. Avoid using
the CD controls while recording to avoid such noises
appearing in your songs.
Displays the track number currently being played.
Displays the time elapsed from
the start of the current track.
Level meter of audio (pre-fader)
recorded to the CD. The stereo
output level can be adjusted
by the MASTER fader.
Displays the track number and track length.
The list of tracks on an audio CD can be viewed by
turning the DATA dial or pressing the §/¶ cursor keys.
Current track number / Total
track number.