Filter
Top Products
LS9 Editor Owner’s Manual
28
❏ MIX SEND
A MIX send level
This adjusts the send level of the signal sent from the input channel to VARI-type MIX bus. The current value is
shown in the numerical box immediately below.
B PRE (Pre/Post)
This selects PRE or POST as the point from which the signal is sent from the input channel to the MIX bus. The
point will be PRE POINT when this is on, and POST FADER when this is off. The PRE POINT setting can be
specified in the Mixer Setup screen.
C ON (MIX send on/off)
This is an on/off switch for the signal sent from the input channel to the MIX bus.
• If MIX buses are being used in stereo, the odd-numbered knob will be PAN.
• If the FIXED type is selected for the MIX bus, only the ON button is valid.
• The stereo/mono setting and the VARI type / FIXED type setting can be made in the
Mixer Setup screen.
❏ HA GAIN/Ø/HPF
A HA (HA Gain)
Adjusts the gain of the internal head amp or of the external head amp (AD8HR) patched to the input channel.
The current value is shown in the numerical box below the knob. You can set this to the default value (+10 dB) by
holding down the <Ctrl>(< >) key and clicking the knob. You can also use the [48V] button to switch phantom
power on/off.
B Ø (Phase)
Inverts the phase of the signal after AD conversion.
C HPF (High Pass Filter)
Use the [ON] button at the right to switch the high-pass filter on/off. You can use the knob at left to adjust the
cutoff frequency. The current value is shown in the numerical box below the knob. An indication of “H” will
appear on the EQ graph of the equalizer.
3
1
2
HINT
Knob of odd-num-
bered side
1 32