Filter
Top Products
LS9 Editor Owner’s Manual
78
F [Room Size]
Size of space. Higher values simulate larger spaces.
This value is linked with the Reverb Time value. When you change this value, the Reverb Time value changes.
Drag the icon to change the value.
The range is from 0 through 28.
G [Diffusion]
Density and spread of reverberation. Higher values increase the density and enhance the spread.
Drag the icon to change the value.
The range is from 0 through 10.
H [HPF]
This filter cuts the low frequency range of the reverberation. The range below the frequency specified by this value
is cut. This filter does not affect the original source sound.
Drag the icon to change the value.
The range is Thru to 8.00kHz.
I [LPF]
This filter cuts the high frequency range of the reverberation. The range above the frequency specified by this
value is cut. This filter does not affect the original source sound.
Drag the icon to change the value.
The range is 1.00kHz to Thru.
J [Hi Ratio]
Length of reverberation in the high frequency range. The reverberation duration of the high frequency range is
expressed as a ratio relative to Reverb Time.
Drag the icon to change the value.
The range is from 0.1 through 1.0.
K [Lo Ratio]
Length of reverberation in the low frequency range. The reverberation duration of the low frequency range is
expressed as a ratio relative to Reverb Time.
Drag the icon to change the value.
The range is from 0.1 through 1.4.
L [Low Freq]
Frequency value that serves as the basis for the Lo Ratio value. The frequency band below this value is affected by
the Lo Ratio parameter setting.
Drag the icon to change the value.
The range is from 22.0Hz through 18.0kHz.
2
3
4
5
6
7
8
9
J
K
L
NOTE
NOTE
NOTE
NOTE
NOTE
NOTE
NOTE