Filter
Top Products
LS9 Editor Owner’s Manual
36
(*)
OMNI jacks 9–16 and SLOT2 can be displayed only if you’re editing offline and have selected LS9-32 in the Model Select field of the
Mixer Setup window, or if you are editing online with the LS9-32 connected.
D DIRECT OUT POINT
Select either PRE HPF, PRE EQ, or PRE FADER as the location at which direct out will be patched.
❏ RECALL SAFE/MUTE SAFE
These enable/disable Recall Safe and Mute Safe for the channel.
❏ MUTE GROUP
A MUTE GROUP
Selects the mute group (1–8) to which that channel belongs.
❏ Fader
A ON
Switches the input channel on/off. This is linked with the INPUT section CH [ON] keys
on the LS9’s panel.
B Fader
Adjusts the input level of the input channel. This is linked with the INPUT section fad-
ers of the LS9’s panel. A meter indicating the signal level is shown at the right of the
fader, and the current value is shown in the numerical box immediately below. You can
set this to the minimum value (–∞ dB) by holding down the <Ctrl>(< >) key of your
computer keyboard and clicking the fader knob, or set it to the nominal value (0.00 dB)
by holding down the <Ctrl>(< >) key and <Shift> key and clicking the fader knob.
C CUE
This button cue-monitors the signal of the input channel. This is linked with the
INPUT section [CUE] keys on the LS9’s panel.
REC IN L, REC IN R L/R channels of the USB memory recorder input
1
1
2
3