Filter
Top Products
LS9 Editor Owner’s Manual
55
CInput patch
Click the CHANNEL field, and choose one of the following as the signal route that will
be patched to the input channel(s) of the currently selected GEQ module. This is linked
with
5 Output Patch
(*)
Displayed only, and cannot be selected.
The channel name is shown in the boxes immediately below.
D Input meter
This indicates the level of the signal that is being input to the currently selected GEQ
module.
E Output patch
Click the CHANNEL field, and choose one of the following as the signal route that will
be patched to the output channel(s) of the currently selected GEQ module. This is
linked with
3 Input Patch.
(*1)
INPUT CH 33–64 can be displayed only if you’re editing offline and have selected LS9-32 in the Model
Select field of the Mixer Setup window, or if you are editing online with the LS9-32 connected.
(*2)
Displayed only, and cannot be selected.
The channel name is shown in the boxes immediately below.
F Output meter
This indicates the level of the signal that is being output to the currently selected GEQ
module.
NONE No assignment
MIX1–16
(*)
MIX channel 1–16
MATRIX1-–8
(*)
MATRIX channel 1–8
ST L, ST R, MONO(C)
(*)
STEREO channel L/R, MONO channel
INS CH 1–32 INPUT CH 1–32 insert out
INS MIX 1–16 MIX channel 1–16 insert out
INS MATRIX1–8 MATRIX channel 1–8 insert out
INS ST L, INS ST R, INS MONO(C)
Insert-out of STEREO channel L/R or the MONO chan-
nel
NONE No assignment
IN CH 1–64
(*1)(*2)
INPUT jacks 1-64
(*1)
STIN1L-STIN4R
(*2)
L/R channels of ST IN jacks 1–4
INS CH 1–32 INPUTCH 1–32 insert in
INS MIX 1–16 MIX channel 1–16 insert in
MATRIX INSERT1–8 MATRIX channel 1–8 insert in
INS ST L, INS ST R, INS MONO(C)
Insert-
in
of STEREO channel L/R or the MONO channel
3 4
6
5