Filter
Top Products
LS9 Editor Owner’s Manual
37
If a MIX channel is selected
❏ CHANNEL SELECT (Channel selection)
A SELECT (Channel selection)
Except for the fact that your editing applies to a MIX channel, this is
the same as the channel selection for an input channel (➥ p.27).
B OUTPUT PATCH
This selects the output port that will be assigned to the MIX chan-
nel. (For the output ports that can be selected (➥ p.18).
If multiple patches have been made, only the first port is shown.
If you change the patching in this window, the port that had been
assigned until then will be cancelled, and only the newly selected
port will be assigned.
❏ TO MATRIX
A MATRIX send level
This adjusts the send level of the signal sent from the MIX channel to the MATRIX
buses.
B ON (MATRIX send on/off)
This is an on/off switch for the signal sent from the MIX channel to the MATRIX bus.
C POINT (Send point)
Select either PRE or POST as the position from which the signal is sent from the MIX
channel to the MATRIX bus. PRE POINT is selected if this is on, or POST FADER is
selected if this is off. The PRE POINT setting can be made in the Mixer Setup screen.
• If you are using MATRIX buses in stereo, the knob for the
odd-numbered bus will be PAN.
• The stereo/mono status can be specified in the Mixer
Setup screen.
1 2
2
1
3
HINT
Knob of odd-
numbered side