Filter
Top Products
LS9 Editor Owner’s Manual
60
EXTERNAL HA page
A maximum of two head amp devices can be connected to the LS9-16, and a maximum of four can be
connected to the LS9-32. #3 and #4 are displayed only if you’re editing offline and have selected LS9-32 in
the Model Select field of the Mixer Setup window, or if you are editing online with the LS9-32 connected.
A External HA name
This shows the model name and ID number of the currently connected external head amp device.
B GAIN
This specifies the gain for each channel. The current value is shown in the box below.
C 48V
This switches the phantom power (+48V) on/off for each channel.
D HPF (High Pass Filter)
This switches the HPF on/off for each channel.
E +48V MASTER
If an AD8HR is connected, this indicates the on/off status of the master phantom power supply.
F Slots/Channels
Here you can select the slots/channels to which the audio outputs of the external head amp device are connected.
(*)
SLOT2 is displayed only if you’re editing offline and have selected LS9-32 in the Model Select field of the Mixer Setup window, or if
you are editing online with the LS9-32 connected.
NONE
SLOT1 1-8
SLOT1 9-16
SLOT2 1-8
(*)
SLOT2 9-16
(*)
NOTE
1 32 4 5 6