Filter
Top Products
LS9 Editor Owner’s Manual
61
This window shows the signal levels of each section in the LS9, letting you check for the presence of signals and
whether an overload is occurring.
This window is divided into INPUT METER, OUTPUT METER and Custom Fader Layer Meter; to switch pages,
click the tabs located at the top of the window.
In order to view the LS9’s signal levels in the Meter window, make sure that LS9 Editor and the LS9 itself
are synchronized.
INPUT METER page
A METERING POINT
Select one of the following as the point where metering will occur.
PRE HPF, PRE FADER, POST ON
B PEAK HOLD
Switches peak hold on/off.
C Meters
These peak level meters show the input level of each channel. The current fader value is shown in the box below.
If clipping occurs at any one of the detection points in the channel, the ∑ segment will light.
Meter window
NOTE
1 2
3