Filter
Top Products
LS9 Editor Owner’s Manual
31
❏ DYNAMICS1/2
You can select one of the following types for each of the two dynamics processors.
If GATE/DUCKING is selected
A TYPE
Indicates the type of the currently selected gate. You can click here to select the type.
B LIBRARY
This button accesses the dynamics library. Clicking this button will open the DYNAMICS page of the LIBRARY
window.
C ON
This button switches the gate on/off.
D Response curve
Indicates the response for the gate of the currently selected channel.
E GR meter
This meter indicates the amount of gain reduction.
F THRESHOLD (Threshold level)
Specifies the level at which the gate will open and close. The gate will open when the key-in signal exceeds this
level, and will close when the signal falls below this level.
G RANGE
Specifies the amount by which the signal is attenuated while the gate is closed.
H DECAY
Specifies the time over which the gate will close after the hold time has elapsed.
I ATTACK
Specifies the time from when the key-in signal exceeds the threshold level until the gate opens.
J HOLD
Specifies the time that the gate will remain open after the key-in signal falls below the threshold.
DYNAMICS1: GATE, DUCKING, EXPANDER, COMPRESSOR
DYNAMICS2: COMPRESSOR, COMPANDER-H, COMPANDER-S, DE-ESSER
L
4
J
7
8
6
9
K
1 235
M