Filter
Top Products
LS9 Editor Owner’s Manual
29
❏ TO STEREO/MONO
Here you can specify how the signal will be sent from the input channel to the STEREO bus / MONO bus.
MODE
• ST/MONO button
When this button is on, the signal will be sent to the STEREO L/R bus and independently to the MONO bus.
• LCR button
When this button is on, the signal will be sent to the L/C/R buses which work in conjunction with each other.
PAN (BALANCE for ST IN)
Adjusts the panning of the signal sent from the input channel to the STEREO bus L/R
channels. You can set this to the center position by holding down the <Ctrl>(< >) key
of the computer keyboard and clicking the knob. This is linked with the [PAN] encoder in
the SELECTED CHANNEL section of the LS9 panel.
ST Switches the signal sent from the input channel to the STEREO bus on/off.
M(C) Switches the signal sent from the input channel to the MONO bus on/off.
PAN (BALANCE for ST IN)
Adjusts the panning of the signal that is sent from the input channel to each of the L/C/
R channels. You can set this to the center position by holding down the <Ctrl>(< >)
key of the computer keyboard and clicking the knob. This is linked with the [PAN]
encoder in the SELECTED CHANNEL section of the LS9 panel.
LCR Switches the signal sent from the input channel to the L/C/R bus on/off.
CSR (Center Side Ratio)
Adjusts the proportion of the CENTER channel level relative to the STEREO bus L/R in
a range of 0–100%.
[INPUT CH 1–48] [ST IN CH 1–4]
[INPUT CH 1–48] [ST IN CH 1–4]